Now that re-shade is fully installed its time to install the additional settings mod

The mod is linked below this file in the Step 3 folder

This is a simple installation and is no different than a mod, drag it into your mods folder and launch the game
 
Before you head into a savegame, make sure to open your game settings, go into advanced settings and 
make sure the antialiasing settings is fully off

Once you are on your mods selectiuon tab select it and use the in-game menu to select the gears button, then go to the lighting
 section and click the arrow until you see "North Lighting" 
(see sample photo linked in step 3 file)

Once selected press shift function 2 (f2) to open the re-shade tab and head over to the tab called 
d3d11, check one of the 4 boxes until the shadows (ambient occlusion) stays on. 
(see sample photo linked in step 3 file)
Once these are all done you are ready to play! make sure you head over to the d3d11 tab and select one of the four boxes 
every time you launch into the game (unfortunately I dont have a way to make it save that setting). I hope you enjoy using my presets! 






Additional notes:


(Through testing I have found out that the files I used in North Lighting (Originating from some map) are actually identical to the basic lighting of additional game settings

therefore it is perfectly fine to just use the original additional game settings mod. 

I also reccomend to try using the ravenport or fellsbrunn lighting options as they look much better at times however it is purely preference based (as shown in attached photos in the step 3 file)

The sample photos were taken using MXA0-9 

The sample photo titled 4 Was taken with Realistic Fog V1 I was using custom seasons lighting at the time and that is why the red on the planter looks dull that will not happen to you


